This site is for Avast Business products only. For articles on AVG Business products, see AVG Business Help. If you are in the right place but cannot find what you are looking for, please contact Avast Business Support for further assistance.

Configuring Cache Clearance

This Article Applies to:

  • Avast Business CloudCare

IMPORTANT: The CloudCare console does not support opening multiple tabs in the same browser session. Please use multiple browsers or incognito mode instead.

UPDATE: As of 19 October 2026, two-factor authentication (2FA) is required for all CloudCare partner, self-managed, and distributor users. As part of this enforcement, 2FA was reset for all users, so you must complete a new setup the next time you log in, even if you previously had 2FA enabled.
This is expected behavior and does not indicate an issue with your account. The new setup uses an updated MFA solution with improved security, so your previous 2FA enrollment cannot be reused.
Thank you for your cooperation in completing this security update. Please contact us if you need assistance.

 

Via the Patch Management settings of a policy, you can configure automatic removal of local patch files in order to free up the end devices' hard drive space for future patches.

To define when the patch cache will be cleared from end devices:

  1. Go to the Policies page (at partner level for master policies or customer level for customer policies)
  2. Select the desired policy from the left-hand pane
  3. Under Endpoint Protection, expand the Patch Management section
  4. Go to the Patch Settings tab
  5. Under Clear local patch cache, choose one of the following options:
    • Immediately after patch deployment
    • 7 days after installation
    • 30 days after installation
    • 60 days after installation